Advertisement
Computer Instructions
1. Display speed in km/h.
2. Display of covered distance
in km.
3. Display current pulse rate
4. Connection of hand pulse wire
.
9.Select-Button to increase the
data of the chosen function
.
5. Reset- Button: to clear
the functional datas
Operating Instructions Computer CT- 550
Batteries:
Open the battery case at the backside of the computer
and insert 2 batteries Mignon AA 1.5 V.
The batteries life is approximately one year under normal
usage.
Start:
As long as the wheel is in motion the computer is in action.
If there is no moving within 4 minutes the computer will
turn off automatically.
Beginning of Training
Please see attached Training Instructions
1. Training without the entering of any data
To set all values back to zero, hold down the Reset-
Button (5) for about 3 seconds.
If you choose not to enter any training data, you may start
training now.
The entered data for time, distance and energy
consumption will be counted upwards.
To display the pulse rate please put both hands on the
sensors of handlebar or use the ENERGETICS chest
transmitter set (optional). Only holding the sensor with 2
hands will make the system working correctly.
After a few seconds your pulse rate will be shown on the
display.
After having finished a training session the achieved rates
will be shown for a further 4 minutes.
If you continue training within this four minutes the
achieved rates data shall be brought forward.
2. Training with the entering of data
To set all values back to zero, press the Reset- button (5)
Entering data:
Time:
Press the Mode- button (8) until data appears in display.
8. Mode- Button: to set
computer functions
9. Select- Button to decrease the
data of the chosen function.
Enter chosen rate in minutes by pressing the
Select-buttons (9).
Distance:
Press the Mode-button (8) until data appears.
Enter chosen distance in km by pressing the
Select-buttons (9).
Energy consumption:
Press the Mode-button (8) until data appears.
Enter chosen amount in kcal by pressing the
Select-buttons (9).
Maximum Pulse rate:
Press the Mode-button (8) until data appears.
Enter chosen rate for maximum pulse rate by pressing the
Select-buttons (9).
Please read the attached Training Instructions to find
your maximum pulse rate or consult your physician.
If your maximum pulse rate is exceeded you will be
warned by a beep.
Mode-button:
Use the Mode- button to set computer functions.
If the Mode-button (8) is pressed for more than 3 seconds,
all entered rates will go back to zero.
Reset-button:
If the Reset-button (5) is pressed all datas will go back to
zero except the Odometer datas (ODO).
Odometer
The Odometer function accumulates the total kilometers
from all the workouts since the batteries were installed.
To display Odometer press the Mode-button (8) until the
value appears in the Odometer display.
In the Odometer display the current value of time will also
be shown.
3. Training with entered data
The entered data will run backwards after starting
- 13 -
6. Display time 0 – 99.59 min.
7.Display energy consumption in kcal.
Advertisement
