Advertisement
Advertisement
Table of Contents
Related Manuals for Star Headlight & Lantern Contour S-Link System 9100DLED DUAL-COLOR MINIBAR
Summary of Contents for Star Headlight & Lantern Contour S-Link System 9100DLED DUAL-COLOR MINIBAR
- Page 1 MODEL 9100DLED DUAL-COLOR MINIBAR featuring the PLIT596 REV. - 10/1/19...
- Page 2 Please Note: These instructions are provided as a general guideline only. Specific mounting, wiring, and/or weather-sealing may be necessary and are the sole responsibility of the installer. Star Headlight & Lantern Co., Inc. assumes no responsibility for the integrity of the installation for this or any of its products.
- Page 3 Mounting Instructions 1. IMPORTANT: Please read all of the following instructions before installing your new warning light. 2. CAUTION: All of our DC powered warning lights are polarity sensitive. These lights are polarity protected only if the appropriate fuse is used. All wires connected to the positive terminal of the battery should be fused at the battery for their rated load.
- Page 4 Electrical Connections WHITE: Synchronization (Optional) - AFTER setting flash patterns connect white wires from synchronized lights together. Cut short and cap off if not synchronizing. RED: Power (Color 2) ORANGE: Power (Color 1) PURPLE: High/Low Power Select - +12VDC for Low / Open for High FUSE RED w/GREEN: Pattern Select - Touch and release to +12VDC BLACK: Good Chassis Ground...
- Page 5 Programming PATTERN PROGRAMMING The Orange and Red wires can each be programmed for its own pattern. 1. Activate the wire that you wish to program (Orange or Red) by connecting it to power (and the Black to Ground). 2. Touch and release the Pattern Select wire (Red w/ Green) to +12 VDC to scroll through the patterns listed to...
- Page 6 (Programming CONT’D) PRIORITY MODES If both colors are activated (either by using both wires, or if you have set one wire for Dual- Color Mode), the default setting is for both colors to flash their pattern, one after the other (No Priority in Sequential Mode).
- Page 7 LED FIVE YEAR LIMITED WARRANTY The manufacturer warrants this LED light against factory defects in material and workmanship for five years after the date of purchase. The owner will be responsible for returning to the Service Center any defective item(s) with the transportation costs prepaid. The manufacturer will, without charge, repair or replace at its option, products, or part(s), which its inspection determines to be defective.
Need help?
Do you have a question about the Contour S-Link System 9100DLED DUAL-COLOR MINIBAR and is the answer not in the manual?
Questions and answers