Electric Connection; Removing The Stainless Steel Plinth (Kook 80 - Kook 90 4.0) - Cadel KOOK 60 4.0 Installation, Use And Maintenance Manual

EN
• Fasten the door stop (see Fig. 32 page 19) and hook the door in its new position (see Fig. 33 page 19).
• NB: the screws removed from the one side must all be fastened on the other side (there must not be any
empty holes in the stove).
11.7

ELECTRIC CONNECTION

Some wood stove models are endowed with a forced ventilation system, so they need an electric connection.
Warning: the appliance must be installed by an authorized technician!
• The electric connection occurs through a cable with plug put in an electric socket which is able to support
charge and tension specific of every model, as described in the technical datas table.
• The plug must be easily accessible when the appliance is installed.
The cable must not get in touch with the fume exhaust pipe and nor with every other part
of the stove.
• Please further assure you that your network is endowed with an efficient earth connection: if it does not exist
or if it is not efficient, please endow you with one in compliance with the law.
• Do not use extension cables.
• If the feeder cable is damaged, it must be replaced by an authorized technician.
• When the stove is not going to be used for a long period of time, it advisable to remove the plug from the
socket on the wall.
11.8

REMOVING THE STAINLESS STEEL PLINTH (KOOK 80 - KOOK 90 4.0)

In the event of installation between kitchen units, we recommend removing the right and left hand stainless steel
plinth.
• Undo the screws above the rh and lh plinth (see Fig. 34 page 20);
• Remove the rh and lh plinth (see Fig. 35 page 20).
Fig. 34 - Undo the screw
If you wish you can remove the front plinth and replace it with that fitted on the kitchen units.
• Undo the screws above the front plinth (see Fig. 36 page 20).
• Remove the plinth (see Fig. 37 page 20).
Fig. 36 - Undo the screw
20
KOOK 60 4.0 - KOOK 67 4.0 - KOOK 70 4.0 - KOOK 80 - KOOK 87 - KOOK 90 4.0
Fig. 35 - Plinth removal
Fig. 37 - Plinth removal