Determining Input And Output Signals; Commissioning And Settings - Baelz Automatic 373-E66 Series Operating Instructions Manual

Operating Instructions

7.3.2 Determining input and output signals

The actuator is either preset to 0...10 V, 0...20 mA or to 2...10 V, 4...20 mA . Depending on the configuration, the
lines for the input and output signals are connected to terminal X4.

7.4 Commissioning and settings

Figure 17: Positioning electronics
Potentiometers
P1 Lower limit adjustment
P2 Upper limit adjustment
P4 Span adjustment
Technical specifications subject to change
W. Bälz & Sohn GmbH & Co.
Phone +49 (0)7131 15 00 0
Turn clockwise to lower the limit
Turn clockwise to lower the limit
Turn counter-clockwise to spread
the potentiometer signal
Koepffstrasse 5
Fax +49 (0)7131 15 00 21
BA 373-E66
Observe copyright protection DIN 34
74076 Heilbronn
www.baelz.de mail@baelz.de
Page 21/37
Germany