Meaning Of Led Signals - Baelz Automatic 373-E07 Operating Instructions Manual

Motorized Linear Actuator

7.5.3 Meaning of LED signals

LED LED
signal signal
green off
1
red off
green off
2
red on
green
3 flashing
red off
green
4
flashing
red on
green
5 and red
flashing
green on
6
red off
green on
7
red on
green on
8 red
flashing
W. Baelz & Sohn GmbH & Co. · Koepffstrasse 5 · 74076 Heilbronn · Germany · www.baelz.de
Meaning
Unit is not initialized. Potentiometer in ideal position for initialization run (between 7.5 and
Unit is not initialized. Potentiometer not in ideal position for initialization run.
(If the red LED is flickering, the position of the potentiometer is at the edge of the optimal range and therefore OK.)
Error during initialization. Unit is not initialized. The flashing red LED shows the number of
the error code: 3 flashes, interval, 3 flashes, interval → error code 3. See also section 7.6.1.
Immediately after the unit is switched on, both LEDs are lit for 2 seconds to show that they
Unit is initialized. DIP 12 set to 1 → error after initialization run, see section 7.6.1
DIP 12 set to 0 → error or alarm during normal positioner operation, see section 7.6.2.
green LED
red LED
Unit is switched off.
Initialization run in progress.
17.5%).
Initialization still possible.
Unit is initialized. No errors.
are in working order.
baelz 373-E07
Seite | Page 28 | 36