Technical Specifications Subject To Change Observe Copyright Protection Din; Decommissioning And Disposal; Troubleshooting - Baelz Automatic 373-E66 Series Operating Instructions Manual

Operating Instructions
When ordering accessories or spare parts, make sure to observe the specifications on the identification label of
your actuator. The actual technical data of the linear actuators and the power supply requirements are the specifi-
cations indicated on the identification label.
Damage to the device caused by non-conforming spare parts!
Attention
Spare parts must comply with the technical requirements specified by the manufacturer.
● Always use original spare parts.

12. DECOMMISSIONING AND DISPOSAL

Dispose of the actuator in accordance with applicable, country-specific regulations and laws.

13. TROUBLESHOOTING

If the actuator does not work properly, proceed as follows to correct the problem:
1 Check that the actuator is correctly installed.
2 Check the linear actuator settings and the specifications on the identification label.
3 Correct the problems as specified in the check list.
(see 13.1 Check list for operational malfunctions on page 35)
4 If the problem cannot be corrected, contact the manufacturer.
5 When sending inquiries to the manufacturer or when returning the device, always provide the following
information:
F no. (factory number = order number)
Type identification
Supply voltage and frequency
Additional equipment
Failure report
6 If, after the inquiry, the problem still cannot be corrected, the device can be returned to the manufacturer.
Technical specifications subject to change
W. Bälz & Sohn GmbH & Co.
Phone +49 (0)7131 15 00 0
Koepffstrasse 5
Fax +49 (0)7131 15 00 21
BA 373-E66
Observe copyright protection DIN 34
74076 Heilbronn
www.baelz.de mail@baelz.de
Page 34/37
Germany