Assa Abloy Norton Wave to Open 704 Installation Instructions page 3

Model 704 Wave to Open Switch
Installation
Prepare Door Jamb
1. Place conduit housing on door jamb with
horizontal centerline between 34" - 48"
(86.4cm - 121.9cm) from floor. (Fig 1)
2. Using conduit housing as a template, mark
and center punch four (4) mounting holes and
conduit hole on door jamb.
3. Using 1/8" bit, drill four (4) mounting holes.
4. Using step drill, create a clearance hole for
conduit. Smooth conduit clearance hole with
deburring tool, if necessary.
Install Conduit Housing
1. If required by local codes, attach wire conduit
(supplied by others) to back of housing and
feed wires through.
2. Align housing to mounting holes on door
jamb and secure with four (4) #8
Round Head Metal Drilling screws.
NOTE: Make sure housing is level.
Install Switch
1. Set LED and Time Delay Settings as desired on
Wave to Open switch. See "LED Setting" and
"Time Delay Setting", page 2.
2. Use small flat head screwdriver to connect
24VDC and activation wiring with terminal
block. (Fig 4) See "Wiring", page 2 and
appropriate wiring diagram of door operator
instructions.
3. Attach Wave to Open switch to conduit
housing using two (2)
Head Machine
Copyright © 2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9370-0002-020 Rev 2 07/20
Phillips
(Fig 3)
M3 x 8.3mm Philips Flat
screws. (Fig 5)
Approved 2020-07-09
34" (86.4cm) Min
48" (121.9cm) Max
Figure 1
Figure 2
Terminal
Block
LED and
Timing
Delay
Figure 4
1-3/4"
( 44.5m m)
Figure 3
Figure 5
3