Table of Contents
Advertisement
SECO-LARM Mechanical Keypad Door Lock
Setting the Lock Code (Continued):
Replace the lock code plate and secure it with the 4 RED screws.
6.
Check the code to ensure accuracy before installing. First press the "C" (Clear) button followed
7.
by the chosen code and move the handle on the keypad assembly to test the lock.
IMPORTANT NOTES:
A. Spare code tumblers are provided to increase the number of code digits if needed.
B. Carefully note each code tumbler's orientation as it is inserted into the lock code assembly.
The square cut should be oriented toward the outside of the housing.
C. Do not leave any code tumbler position empty.
D. Store the manual, actual code, and unused code tumblers in a safe place.
Determine Door Swing and Handedness:
Determine whether the door is right- or
left-handed.
When facing the door from the outside, if the hinge
is on your right, then the door is right-handed. If
the hinge is on your left, the door is left-handed
(see Fig. 4).
Prepare the Door and Install the Latchbolt:
Fold the template on the dotted line and place it on the door
1.
so that the line marked "Latch center line" is aligned with the
latch strike plate's center line when the door is closed. Use
tape to hold the template temporarily in place (see Fig. 5).
Drill the six
/
" (10mm) holes as shown on template.
2.
3
8
Viewing the door from the latch edge, mark the horizontal
3.
center point on the "Latch center line" and drill a 1" (25mm)
hole to a depth of 3
Use a chisel to form the 4 horizontally-aligned
4.
holes into a single slot.
Insert the latch into the latch hole and mark around the
5.
faceplate to determine the size of the recessed area needed
to allow the faceplate to be flush with the door.
After marking around the faceplate, remove the latch and
6.
use a chisel to cut a
will ensure that the faceplate fits flush with the door (Fig. 6).
Insert the latch assembly, ensuring that curved part of the
7.
latchbolt is correctly oriented for the door's swing. Secure
the latch assembly with 2 wood screws provided.
4
/
" (95mm).
3
4
/
" (3mm) deep hole as marked. This
1
8
Fig. 4
Right-handed
to form holes
/
" (10mm)
3
8
SECO-LARM U.S.A., Inc.
Inside
Left-handed
Outside
Fig. 5
Latch
center
line
Use chisel
into a slot
Fig. 6
Cut a
/
" (3mm)
1
8
deep hole
Advertisement
Table of Contents
