ADJUSTING DELAY TIME AND SPEAKER OUTPUT LEVELS
When using the digital sound field processor including the Dolby Pro Logic Surround decoder or the Dolby Digital decoder, you can
adjust the delay time between the main sound and effect sound, and each speaker's output level as you prefer.
If you are using the remote control transmitter, set the
SELECTOR DIAL to the AMP/TUN or DSP position on the
remote control transmitter.
Press TIME/LEVEL once or more until the name of item
which you want to adjust appears on the display.
* After pressing TIME/LEVEL once on the remote control
transmitter, you can also select the name of item by
When pressed, the selection changes as follows:
D E L A Y
Center speaker output level
C E N T E R
Right rear speaker output level
R S U R .
Left rear speaker output level
L S U R .
Subwoofer output level
S W F R
on the remote control transmitter changes the
selection in the reverse order.
* Depending on the mode of this unit, you cannot select all
Press + or – to adjust the settings for delay time or
speaker output levels.
Repeat steps 1 to 3 to adjust settings on any other
3/25/99, 3:54 PM