Setting The Sleep Timer - Yamaha DSP-A595 Owner's Manual

If you use the SLEEP timer of this unit, you can make this unit automatically switch to the standby mode. When you are going to
sleep while enjoying a broadcast or other desired input source, this timer function is useful. The SLEEP timer can be controlled
only with the remote control transmitter.
Notes
• To set the SLEEP timer for this unit, set the SELECTOR DIAL to a position other than the TV postition. To set the SLEEP timer
for your TV, set the SELECTOR DIAL to the TV position.
• The components on which the SLEEP timer is effective are the sources connected to the SWITCHED AC OUTLET(S) on the rear
panel of this unit.
To set the SLEEP time
1
Press SLEEP once or more to select the desired
SLEEP time.
Remote control
Indicates the SLEEP time.
Whenever SLEEP is pressed, the SLEEP time will change
as follows.
120
The SLEEP timer is off (SLEEP OFF).
(The state before SLEEP is
pressed.)
After a while, the "SLEEP" indicator lights up and the display
returns to the indication before the SLEEP timer was set.
2
The unit will be switched to the standby mode automati-
cally at the selected SLEEP time.
28
DSP-A595-3

SETTING THE SLEEP TIMER

1
Flashes.
(Minutes)
90 60 30
28
To cancel the selected SLEEP time
Remote control
Press SLEEP once or more so that "SLEEP OFF" appears on
the display. (It will soon disappear and the "SLEEP" indicator
will go off from the display.)
Note
The SLEEP timer setting can also be canceled by tuning this
unit into the standby mode with STANDBY/ON on the front
panel (or STANDBY on the remote control transmitter) or
disconnecting the power plug of this unit from the AC outlet.
3/25/99, 3:53 PM