Set A or B (or both A and B) to the ON position for the main
speaker system (connected to this unit) you will use. Set it (or
them) for the main speaker system you will not use to the OFF
Switches on and off the output from the center and rear
speakers so that the sound becomes normal 2-channel.
* Even if the output from the center and rear speakers is off,
when the Dolby Digital is decoded, the signals at all channels
are distributed to the main channels and output from the main
Press these buttons to select the DSP program.
The name of the selected program appears on the display.
These controls are effective only for the sound from the main
Used to increase or decrease the low frequency response. The
"0" position produces flat response.
Used to increase or decrease the high frequency response.
The "0" position produces flat response.
This control is effective only for the sound from the main
Adjusts the balance of the output volume to the left and right
speakers to compensate for sound imbalance caused by
speaker location or listening room conditions.
Press this button to select functions in the SET MENU mode.
Press this button to select the setting of delay time or speaker
output levels in the TIME/LEVEL mode.
These buttons are used to adjust settings of the SET MENU
mode and the TIME/LEVEL mode. In the TIME/LEVEL mode,
press + to increase delay time or speaker output levels. Press
– to decrease delay time or speaker output levels.
Switches the DVD/LD and TV/DBS input signal mode (AUTO/
VIDEO AUX terminals
Connect an auxiliary video or audio input source unit such as a
camcorder to these terminals. If the connected video unit has a
S video output terminal, connect it to the S VIDEO terminal to
obtain a high resolution picture. The source connected to these
terminals can be selected by INPUT.
3/25/99, 3:53 PM