PLAYING A SOURCE WITH THE DIGITAL SOUND FIELD PROCESSOR (DSP)
Follow steps 1 to 7 shown in "BASIC OPERATIONS" on
pages 24 to 25.
Select the desired DSP program that is suitable for the
Press DSP. While the indicator lights up for about three
seconds, select a DSP program using the numeric buttons
(1 to 8).
* If the SELECTOR DIAL is set to the DSP position, you
can also select a DSP program using the numeric buttons
(1 to 8).
The name of selected program appears on
If desired, adjust the delay time and the output level of
each speaker. (For details, see pages 33 and 34.)
• You can select the program for each of the input sources.
Once you select a program, it is linked with the input source
selected at that time. So, when you select the input source
next time, the same program is automatically called.
• If you prefer to cancel the DSP, press EFFECT or EFCT ON/
OFF. The sound will be the normal 2-channel stereo without
surround sound effect.
• When a monaural sound source is played with DOLBY PRO
LOGIC or DOLBY PRO LOGIC ENHANCED, no sound is
heard from the main speakers and the rear speakers. Sound
is heard only from the center speaker. However, if the NONE
position is selected on "1. CNTR" in the SET MENU mode,
the main speakers output the sound of the center channel.
• If the main-source sound is considerably altered by
overadjustment of BASS or TREBLE when this unit's Dolby
Pro Logic Surround decoder or Dolby Digital decoder is used,
the relationship between the center and rear channels may
produce an unnatural effect.
3/25/99, 3:54 PM