Table of Contents
Advertisement
ONLINE ELECTRONICS LTD
5.7. OPENING THE HOUSING
The instructions detailed within the product certificate and section 10 CERTIFICATION APPENDIX
of this manual must be followed at all times.
1.
⚠ WARNING – DO NOT OPEN WHEN ENERGIZED.
2.
Using a 3mm AF Allen key loosen the M4 locking screw located
at the 12 o'clock position on the REAR ENDCAP 6x full turns.
3.
Carefully unscrew the rear endcap REAR ENDCAP while being
prepared to take the weight when it disengages. There are 4x
unthreaded holes around the perimeter of the endcap which may
be used should leverage be required.
5.8. CLOSING THE HOUSING
Gently hand tighten the REAR ENDCAP. Do not use tools or over
tighten otherwise the endcap will be difficult to remove. The M4
locking screw should be at the 12 o'clock position when the endcap
is fully engaged, there should still be a small gap (<0.5mm) between
the endcap and housing.
1.
Using a 3mm AF Allen key gently tighten the M4 locking screw
located at the 12 o'clock position on the REAR ENDCAP. Do not
over tighten, very little torque is required to lock the endcap in
place.
ID5001P_5001_B00
Page 21 of 36
Advertisement
Table of Contents
