Table of Contents
Advertisement
ONLINE ELECTRONICS LTD
4.5.5.
OUTPUT CONFIG MENU
The OUTPUT CONFIG MENU allows the user to configure the
output functionality of the unit. This menu consists of two
pages as shown.
OUTPUT DELAY – Select this item to modify the OUTPUT
DELAY in HH:MM:SS format. The OUTPUT DELAY dictates
how long the unit will indicate DETECTION before returning
to LISTENING mode. This can take any value from 00:00:00
up to 98:59:59.
CL OUTPUT – Select this item to enable or disable the
CURRENT LOOP output functionality. If the CURRENT LOOP
output is disabled the loop current will be 2mA, otherwise,
the loop current will be either the user defined LISTENING
or DETECTION level.
CL LISTEN – Select this item to edit the CURRENT LOOP
LISTENING level (4.0 – 20.0mA).
CL DETECT – Select this item to edit the CURRENT LOOP DETECTION level (4.0 – 20.0mA).
CL IF – This item should not be changed by the user. This will be configured at the time of
manufacture to interface with the ID5000IF unit if required.
RELAY INVERT – Select this item to enable or disable the inverse operation of the relay.
LED FLASH – Select this item to enable or disable the flashing high brightness LEDs fitted above
and below the LCD display.
VAL SD LOG – Select this item to enable or disable logging of the raw data to the internal SD
card (if fitted).
FFT SD LOG – Select this item to enable or disable logging of the FFT data to the internal SD
card (if fitted).
RESET TO DEFAULTS – Selecting this item will reset all output parameters to their default
values. This option requires the user to confirm before it is actioned.
ID5001P_5001_B00
Page 14 of 36
Advertisement
Table of Contents
