Assembly Instructions - Bat-caddy X4 Series User Manual

ASSEMBLY INSTRUCTIONS

1. Unpack all items carefully and check inventory. Place frame structure (one piece)
on soft clean ground to protect the frame from being scratched.
2. Attach rear wheels to axles by pushing the wheel locking button (Pic-1) on the
outside of the wheel and inserting the axle extension in to the wheel. Make sure
to keep the spring clip (PIC-2) on the outside of the wheel depressed during
this process, in order to enable the wheel to be inserted fully onto the axle
sprocket. If you have inserted the wheel correctly onto the wheel when you
release the spring clip it will lock onto a groove on the end of the axle. If not locked
properly, the wheel will not be connected to the axle and will not be propelled! Test
the lock by trying to pull the wheel out.
Pic-1
3. The X4 Classic & X4 Sport caddies have a specific right (R) and a left (L)
wheel (Pic-3), as seen from behind in driving direction. Please make sure
that the wheels are assembled on the correct side, otherwise the clutches
will not engage. To disassemble the wheels, proceed in reverse order.
Note: The X4 Pro & X4R rear wheels are interchangeable. They fit on either side.
4. Erect Frame by unfolding and connecting the main frame tubes together
at the two frame locks. On the lower frame lock screw (Pic-2) make sure
the middle frame piece sets securely against the lower frame so the screw
line up with the threaded insert. One the upper locking screw (Pic-3) you
have a range of adjustment to the height depending on your preference.
5. Proceed in reverse for folding the caddy.
X4 Series
Pic-2
Pic-2
5
Left, Right Markers
Pic-3
Pic-3