Thermometer - Henny Penny HC-4 Service Manual

2-9. INDICATING LIGHTS
(Continued)

2-10. THERMOMETER

4. Remove the light by squeezing the retainers on the body and
pushing the light out through the control panel.
5. Install a new light by pushing it through the front of the con-
trol panel until it snaps securely in place.
6. Strip the ends of the cut wires and connect them to the new
light with wire nuts.
7. Push the control panel back in place and put in screws.
8. Reconnect the electrical supply to the cabinet.
Step 4
1. Disconnect the electrical supply to the cabinet.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove the access panel from the top of the module.
3. Remove the four (4) screws from the control panel and pull
Step 4
it down.
4. Remove the four (4) nuts that hold the blower box to the
cabinet.
5. Lift the blower box up to expose thermometer and thermostat
bulbs.
6. While holding the blower box, remove the two nuts that
secure the bulb retaining clamps and remove the thermometer
Step 6
bulb from the clamps.
7. Remove the two (2) nuts that hold the mounting brackets
on the back of the thermometer body.
8. Remove the thermometer by pulling the body and capillary
tube through the control panel.
9. Install a new thermometer in reverse order.
Step 7 10. Reposition the blower box and secure it with the four (4)
nuts previously removed.
2-7