Storing The Appliance - Moulinex VOLUPTA Manual

• The accessories, drive shaft and lid parts can
discolour slightly with some ingredients such
as curry, carrot juice etc. this presents no
danger to your health or to the operation of
your appliance. To avoid this, clean the items
immediately after use.

STORING THE APPLIANCE

To help with storing your appliance, the accessories and drive shaft can be kept in the jug in the
order shown in figure 17 followed by the lid assembly (cup, lid).
WHAT TO DO IF YOU APPLIANCE DOESN'T WORK
PROBLEMS
Insufficient cooking
Unsatisfactory steaming
Difficulties succeeding with some
recipes
The appliance doesn't work
The lid does not lock or locks with
difficulty.
Excessive vibration or noise.
• Before reusing the jug (F), make sure that the
electrical contacts under the jug are always
clean and dry.
CAUSES
The cooking times are for guidance
only and in most cases allow for
satisfactory cooking.
Nevertheless, certain conditions will
influence the cooking time:
- the size of the vegetables (cut or
not cut)
- the quantity of ingredients
- the variety of vegetables, and their
maturity
- If the ingredients are frozen or not
....
Inappropriate quantity of water in
the jug.
Pieces too large.
Unsuitable recipes.
The power cord is not plugged in.
The motor-unit lid is not fully
assembled.
The appliance is not on a flat surface,
the appliance is not stable.
Too many ingredients have been added.
A problem with the accessories.
30
SOLUTIONS
Add further cooking time using the
button (B10).
Reduce the size of the pieces.
The amount of water in the jug must
correspond to the mark (400 ml/0.4L).
Reduce the size of the pieces.
Your recipes, whether your own or
found on the internet, may not be
suited to your appliance and its
accessories (quantities, cooking
time, processing time, inappropriate
accessories). Before you begin your
recipe, make sure that you read the
instructions for use shown in this
instruction manual.
Check the connection between the
cord and the base, at the rear of the
appliance. Insert the plug into a power
socket.
Check that the sealing ring is correctly
assembled on the seal-mounting cup
and that it is correctly assembled on
the motor-unit lid (Fig. 5 to 8).
Place the appliance on a stable surface.
Reduce the quantity of ingredients
added.
Check that you are using the
recommended accessory.
EN