Cleaning The Appliance - Moulinex VOLUPTA Manual

MAKING YOUR APPLIANCE ("SECU")
Your appliance comes equipped with electronic
EN protection of the motor to guarantee its
longevity. This electronic security protects
against any abnormal use; meaning that the
motor is properly protected.
In cases of extreme use, which disregard the
recommendations in the instruction manual
(see section "ACCESSORIES, PROGRAMMES AND
QUANTITIES), the electronic protection will be
triggered to preserve the motor.
This can occur when you use your own recipes
(from the internet or other sources) and the
quantities may be too high and/or the processing
time is abnormally long and/or processing a
succession of recipes too close together without
sufficient cooling time in between. In this event,
the appliance stops and the message "SECU" will
appear on the control panel's LCD display to
indicate that the appliance is momentarily non-
operational.

CLEANING THE APPLIANCE

• The appliance must not be immersed
in water. Do not put the base or motor-
unit lid (D1) under running water.
Once you have finished using the appliance,
unplug it from the power socket.
• Remove the motor-unit lid assembly (D1+D2)
from the jug (F) by turning it in an anti-
clockwise direction to move the "open padlock
" opposite the handle.
• Remove the sealing-mount cup (D2) from the
motor unit by pulling it (Fig. 18).
• Remove the sealing ring (D3) from the seal-
mounting cup (Fig. 19).
• Clean the jug immediately after use to avoid
staining.
• Remove the jug (F) from the base of the
appliance (A), holding the grip handle (F1)
(Fig. 2).
• Place the jug on a flat surface.
• When the parts have cooled:
– Take care with the chopping blades (G1)
and the kneading/crushing blade (G2)
when you clean them and when you empty
the jug because they are extremely sharp.
If "SECU" appears on your control panel and
your device stops, proceed as follows:
• Leave your appliance plugged in.
• Refer to the
instruction manual to re-adapt your dishes
quantities of ingredients / processing times
/ type of accessories (see. § "ACCESSORIES,
PROGRAMMES AND QUANTITIES").
• Wait half an hour for the motor to cool down.
• Reset the device by pressing the "Start / Stop
/ Reset" button for 2 seconds (B9).
Your appliance is ready to be used again.
The customer service team remains at your
disposal for any questions (see contact details
in the separate booklet).
– Clean the jug (F), drive shaft (E), accessory
used (G1, G2, G3, G4, G5), seal-mounting
cup (D2) and sealing ring (D3), using a
sponge, hot water and washing up liquid.
• The jug, sealing-mount cup, sealing ring, drive
shaft and accessories, can be washed in the
dishwasher (Fig. 15).
• If there is a build-up of limescale in the jug,
you can use the scourer side of a sponge
dampened if necessary with white vinegar, or
with cleaning products suitable for stainless
steel.
• In the case of stuck-on grime, leave it to
soak for several hours with water and a little
washing-up liquid and scrape if needed with a
spatula or the scourer side of a sponge.
• To clean the motor unit (D1) and the base
(A), use a damp cloth. Dry it carefully.
29
recommendations in this