Rt Ks-2 Torch Installation - ESAB RT KS-2 Instruction Manual

5 INSTALLATION
2 - Burndy connector
4 - Control cable plug
Pinii conectorului Burndy
A. Duză pentru gaz cu simț
tactil
C. Senzor de coliziune
D. Senzor de coliziune
E. Comandă prin închideri
succesive rapide
If the robot control provides a control circuit for nozzle sense functionality, the connection is
accomplished with a 1-wire connection.
Rating of the control circuit: max 50 V / 5 A.
PERICOL!
If the nozzle sense function is not being used, the open end of the control cable on
the power source connection side must be properly isolated in order to avoid short
circuits. During certain problems on the torch head, the full welding potential may be
present on this cable.
ATENȚIE!
After detection of contact (gas nozzle on work piece), quickly reduce or cut off the
maximum current in the nozzle sense circuit in order to avoid overloading of the
system.
Allowed load max. 1 minute at the rated nominal current.
5.1.5 RT KS-2 Torch installation
Continue according to section "Torch installation".
0463 373 101
5 - RT KS-2 connector for control cable plug
F. 0 V
G. + Tensiune motor
H. - Tensiune motor
- 29 - © ESAB AB 2018