Torch Installation With Adjustable Mount - ESAB RT KS-2 Instruction Manual

5 INSTALLATION
4. Position the mount on the RT KS-2 and carefully insert the cylindrical pins (14) into the
holes provided. Take the position of the torch into account. Two mounting positions
may be potentially possible.
5. Screw the mount evenly using the enclosed cylinder screws with hexagon socket (12).
NOTĂ!
The maximum tightening torque for the cylinder screw (5) is 6 Nm (53 in. lb)
and the property class category is 8.8.
5.1.1.1

Torch installation with adjustable mount

Torch mounts with a central clamping assembly can only be fastened on the journal of the
mounting flange. For this, the mounting flange must be fastened first.
1. If applicable, carefully press the cylindrical pins (1) into the corresponding holes in the
mounting flange. The pins should protrude by approximately 5 mm (0.2 in.).
2. Position the mount on the safety-off mechanism RT KS-2 and carefully insert the
cylindrical pins (1) into the holes provided. In doing so, take the later position of the
torch into account. Two mounting positions may be potentially possible.
3. Then screw down the mounting flange evenly using the enclosed cylinder screws with
hexagon socket (2).
NOTĂ!
The maximum tightening torque for the cylinder screw (2) is 7.1 Nm (62.8
in. lb) and the property class category is 8.8.
0463 373 101
12 - Cylinder screw with hexagon socket
M6 DIN 912 (length of the screw depending
on the torch mount)
14 - Cylindrical pins Ø4×20
- 24 - © ESAB AB 2018