GCC Technologies LaserPro Venus II User Manual page 77

3D Mode:
3D Mode allows the naked eyes to visualize the curvatures of the 3D effect by applying 2 00
grayscale power level technology to create different depth of engraving.
Stamp Mode:
The stamp mode is one of the more dynamic functions of the LaserPro laser engravers by
applying 200 power leve to create different steps.
NOTE
Selecting the Stamp mode will enable the Stamp page on the laser Print Driver,
allowing you to adjust advanced stamp-related settings.
Raster & Stamp Mode:
Select this mode when you would like to engrave image on stamps. The Raster & Stamp mode
combines the 256 level gray scale image processing technology and 200 power level stamp
steps production requirement to create slopes.
DPI (Options Page) [DEFAULT SETTING: 500]
DPI (dots-per-inch) represents the number of times the laser will fire over a one -inch path. This
setting determines the image resolution and quality when performing raster engraving functions.
Higher DPI settings result in cleaner and deeper engravings, but require more time to complete.
Lower DPI settings result in coarser and shallower engravings, but require less time to complete.
The LaserPro VENUS offers 8 DPI options: 125, 250, 300, 380, 500, 600, 760, and 1000
experiment with different settings to get your desired effect.
Below is a chart for your convenience detailing the Set DPI (your input setting) vs. Actual DPI
(your output results).
- 77 - 232001280G(13)