Flow Sensor Operation (Optional)
The flow sensor automatically monitors the infusion flow rate through the drip chamber. The flow sensor will
A
cause the pump to alarm if a significant deviation from the infusion rate occurs. The flow sensor will also be able
to detect empty containers. For this reason we recommend use of a flow sensor wherever possible excluding
secondary infusions.
IVAC® Model 180 Flow Sensor
1. Plug the flow sensor into the flow sensor interface located on the top rear part of the pump.
2. Attach the IVAC® Model 180 Flow Sensor to the drip chamber of the infusion set, by pulling back the handles. Refer to the illustration
above.
3. Proceed with load, priming, and set-up instructions as described in section 'Getting Started' .
NOTE:
Ensure drip chamber is half full and upright.
Always attach the flow sensor before you start an infusion .
A
Avoid using the flow sensor in direct sunlight.
Always ensure lens is clean.
Flow
Sensor
Interface
Cover
Always replace the flow sensor interface cover when the flow sensor is disconnected.
A
Pull back handles
Flow sensor
interface
1000DF00546 Issue 5
Alaris™ GP (Guardrails™) Volumetric Pump
Flanges
Handles
Alaris®
Guardrails
®
GP
34/50
Flow Sensor Operation (Optional)
Drip
chamber