Start-Up Of Imb-Pb Connection Modules - IBR IMB-im2 Instruction Manual

Instruction Manual
- Telnet Menu „WLAN" :
Enable WLAN :
Find Network Name :
Enable Ad Hoc Network Creation :
Security :
Data Rate :
Power Management :
Note : Be careful with these WLAN settings because a RESET to default
settings is only possible by demounting the IMB-wla in the factory.
- Telnet Menus „Channel 1",Channel 2", „E-Mail", „Expert", „Security" and „Factory Defaults" :
These settings must not be changed !!!
5. Short description : Configuration of IMB-wla modules for network connection by a notebook
- Set IP-Address of Notebook to i.e. 169.254.100.100
- The IMB-wla module must be found after power-on as W-LAN Network „LTRX_IBSS" on the Notebook
!!! Note :
- On the Notebook the usage of Ad-hoc networks must be activated.
- Install IMB_Test and open the Setup-Window
- By Telnet the IMB-wla module can be configured

4.6 Start-up of IMB-pb connection modules

1. Advantages of Profibus-interface :
- Standard interface for the connection of devices to PLC control units.
- Simple implementation of IMB-pb modules in a PLC-software.
2. Electrical connection :
- Connect the IMB-pb module to IMBus as described under 2.3.
- Connect Profibus connection cable (
Switch IMB power supply module on.
-
IMBus
By this menu point the WLAN interface of the IMB-wla module is activated / deacti-
vated. This menu point MUST be set in any case to „Y".
Network name of IMB-wla module
Settings of Ad Hoc Network ( Network Name, Country and WLAN-
Channel ). On deactivation an Infrastructure network is activated.
Activation of WEP
WLAN data rate
Activation of the Power Management
The Power Management MUST not be activated.
is NOT part of the shipment
18
) to IMB-pb module.