Error Messages; Error Message - Yamaha RM1x Owner's Manual

3. Error messages

3. Error messages
•Monitor
No Data
Illegal Input
Illegal Track Number
Illegal Phrase Number
Illegal Measure
Illegal Check Box
No F7 (End of Exc.)
Preset Phrase
Preset Pattern
Pattern Length Mismatch
Phrase Number Overflow
•System
Backup Battery Low
Memory Full
Factory Set
Memory Protect
•MIDI
Exc. Adrs Error
Exc. Data Error
MIDI Buffer Full
144
RM1x SEQUENCE REMIXER
When a job is executed, this will appear if the selected track or area contains no data,
making the job invalid. Re-select the area.
This will appear in response to inappropriate operation or input. Check your input
method.
An unavailable or otherwise improper track number has been specified. Select a
different track.
An unavailable or otherwise improper phrase number has been specified. Select a
different phrase.
An unavailable or otherwise improper measure number has been specified. Select a
different measure number.
This message will appear if no check boxes are checked in any of the corresponding
track jobs. At least one check box must be checked.
This message indicates that no "End of Exclusive" byte (F7) was included with a
MIDI exclusive data entry or edit. Be sure to include F7.
This will appear when you attempt to edit a Preset Phrase. If you wish to edit a preset
phrase, you must first copy it to a User Phrase.
This will appear when you attempt to record to a Preset Pattern. You cannot record to
Preset Patterns.
A job has resulted in a pattern having more than the maximum of 256 measures.
All available user phrases (256 maximum) have been used up when recording,
executing a job, or editing.
This will appear when the internal backup battery of the RM1x has run down. Contact
nearest Yamaha dealer or the authorized distributer for your country to have the battery
replaced.
This will appear when internal memory is full and it is not possible to record, edit,
execute a job, receive MIDI, or load from floppy disk. Delete unneeded songs,
patterns, or user phrases, and try the operation once again.
After the power is switched ON, a system diagnosis is run on the RM1x's system. If
the diagnosis finds the RAM to be defective, this message will appear and the memory
will be reset to its original factory settings. Data for User Song, User Patterns, and
User Phrases will all be eliminated.
You have attempted to execute a recording, editing, or job function when the UTILITY
mode Memory Protect function is ON.
This appears when the received Exclusive data contains an address error.
This appears when the received Exclusive data contains a data size error.
This will appear when the MIDI reception buffer of the RM1x has filled up, and
processing is not possible. Try decreasing the amount of data or increasing the interval
time and transmit the data once again.