Yamaha RM1x Owner's Manual page 98

12. Job
Job 34 Split Pattern
1
3
4
This job splits a selected pattern into two patterns.
The job splits the pattern at the first beat of the specified meas-
ure. The initial portion of the pattern (up to the split point)
remains in its original location, while the portion starting af-
ter the split point is moved and becomes the destination pat-
tern. (If no phrases start after the split point, the destination
pattern becomes empty.)
The job overwrites any data already existing in the destina-
tion pattern.
1. Source style, section
The upper Style and Section settings select the pattern
to be split.
Settings : Style
Section A ... P
2. Split point
The "M" value selects the measure at which the pattern
is split. This becomes the start point of the destination
phrase.
Settings : 001 ... source-pattern length
3. Destination style, section
The lower Style and Section settings select the new lo-
cation for the portion of the pattern that begins at the
split point.
Settings : Style
Section A ... P
4. Keep Original Phrase
Check this box if you do not want to alter the original
phrase data.
98
RM1x SEQUENCE REMIXER
2
U01 ... U50
U01 ... U50
Job 35 Clear Pattern
1
This job deletes all data from the selected pattern(s).
If you set Style to "ALL", the job executes a total deletion -
removing all sections of all styles. In this case, the job also
reinitializes all play-effect and pattern-voice settings for all
styles.
Note that it is not possible to Undo a total deletion. Be sure
that you really want to delete all patterns before executing a
Style=ALL deletion.
If you set Style to a numerical value and set Section to "ALL",
the job deletes all sections (all patterns) within the selected
style. It also reinitializes all play-effect and pattern-voice set-
tings for that style. (If you make an error with this type of
deletion, however, you can recover by running an Undo.)
1. Style and section
The style and section values select the pattern(s) to be
deleted.
If you set Style to "ALL", then Section is also forced to
"ALL".
Settings : Style
Section A ... P, ALL
Job 36 Style Name
You use this job to set or change the style name.
Maximum length for these names is 8 characters.
Use display knobs 1 and 2 to select a character location and
character, then press the F2 function button (Enter) to enter
the specified character at the selected location. The F1 func-
tion button (Delete) can be used to back up one character lo-
cation and delete the character at that location. Repeat until
the style name is complete.
U01 ... U50, ALL