Voice Edit - Yamaha RM1x Owner's Manual

8. Voice Edit

You use this page to edit the sound characteristics of the voice(s) played on the selected track. You can make separate edit
settings for each track.
Settings do not apply to the voices themselves, but only to the track. If the track's voice changes, the settings operate on the
new voice. If you use the same voice on different tracks with different edit settings, the sound characteristics may be quite
different.
These settings are applied as offsets to the voice's original, internal settings.
EG
Track number
Parameter
Attack Time
Decay Time
Release Time
Track number
Transpose
* For information about how to change values, refer to the Basic Operation (page26).
These values control how volume changes over time, starting with the initial note strike and ending at the point where the sound
dies out. (Note that "EG" stand for envelope generator.)
Values
-64 ... 00 ... +63
-64 ... 00 ... +63
-64 ... 00 ... +63
01 ... 16
-36 ... 0 ... +36
EG
Level
Attack Decay
time time
Key on Key off
Function
Sets the time it takes for the sound to climb to its peak volume,
starting from its initial level of 0 (at the moment when the "key" is
first "struck"). Low values produce a rapid volume rise, while higher
values produce a more gradual climb.
Sets the time it takes for the volume to drop from its peak level to its
"sustain" level. Lower values produce crisper, clearer sounds.
Sets the time it takes for the volume to fall to 0 following the "physi-
cal" release of the note. The lower the value, the faster the sound
will go off.
Shows the current selected track number. Track number selection
can be accomplished via this parameter, or by the keyboard method
described on page 27.
Shows the current transpose value. Transposition can be accom-
plished via this parameter, or by the keyboard method described on
page 27.
Release
time
Time
8. Voice Edit
Transpose
65
RM1x SEQUENCE REMIXER