Yamaha RM1x Owner's Manual page 59

Gate time
This value adjusts the gate times of the notes on the track.
Adjustment is made by multiplying the original gate time
by the modifier value (percentage).
The gate time denotes the length of time that a note is
held. For non-percussive voices, the gate time is equal to
the actual playback time span.
If you set this value to 100%, the original gate times will
be used. Setting the value below 100% will lower the gate
times, while higher values will increase them.
If an adjusted gate-time value is less than 1, the RM1x
will use a value of 1.
Original data
(Gate)
48 48 95
Gate time modifier = 50%
(Gate)
24 24 47
Gate-time modifier = 150%
(Gate)
72 72 142
Velocity offset
You use this parameter to apply an offset to the track's
velocity values.
Positive values increase the playback velocity, while nega-
tive values decrease it.
Original data
(Vel)
96 64 32
VELOCITY OFFSET = -20
(Vel)
76 44 12
VELOCITY OFFSET = +20
(Vel)
116 84 52
Recording the PLAY FX Settings
The grid groove settings can actually be merged into the se-
quence data as follows.
1 Make the PLAY FX settings as described above.
2 Press the [PATTERN] button to go to the Pattern play-
3 Press the REC
4 Set the REC TYPE parameter to "OVERDUB."
5 Press the PLAY
6 Press the STOP
86 48
43 24
129 72
127 96
107 76
127 116
back mode.
button to engage the record
standby mode.
button to begin recording. You
don't actually need to record any new data; the grid
groove setting will automatically be recorded.
button to stop recording after
the pattern has played through once. The PLAY FX
settings will automatically be initialized when record-
ing is stopped.
4. Play FX
59
RM1x SEQUENCE REMIXER