Messages; Error Messages; Warning Messages - Yamaha RSio64-D Owner's Manual

Messages

Messages
Errors, warnings, and certain other types of information
are displayed via the RSio64-D front panel indicators.
Messages are also displayed in the Dante Controller Error
Status field.
Each indicator lights or flashes as described below:
No call-out The indicator is off.
Light The indicator remains lit steadily.
Flash The indicator continues to flash.
Flash x2 The indicator flashes twice cyclically.
Flash x3 The indicator flashes three times cyclically.

Error Messages

When an error occurs, the indicators for all channels will
flash until the error is resolved, and the SYSTEM indicators
will light and/or flash cyclically as shown in the chart
below.
[SYSTEM] Indicators
(red)
Flash x2
(red)
Flash x3
(green) (red)
Lit Flash x2
(green) (red)
Lit Flash x3
(red)
Lit
(red)
Flash
22
Owner's Manual
Description Possible Solution
An internal error
has occurred.
The device has
failed. Contact
Communication
your Yamaha
cannot occur
dealer for repair.
because the MAC
address setting
has been cor-
rupted.
Check that noth-
ing is caught in the
The cooling fan fan. If the problem
has stopped. persists, consult
your Yamaha
dealer.
When using the
unit in [NORMAL]
mode, if the prob-
The internal mem-
lem persists even
ory has been cor-
after turning the
rupted.
power off and on
again, consult your
Yamaha dealer.
Set a unique UNIT
UNIT ID is not
ID number for the
unique.
Dante network.
The function set- Check the function
ting DIP switches setting DIP switch
are not set cor- settings, and set
rectly. them correctly.

Warning Messages

The indicators will light and/or flash as shown until the
cause is resolved.
If the green [SYNC] indicator is unlit, the unit's clock is
unconfirmed.
[SYNC] Indicators Description
The word clock is
(orange)
not set correctly.
Flash
Dante Network cir-
(orange)
cuit is broken.
Flash x2
Other Dante-com-
patible devices
cannot be found
(orange)
due to an incor-
rectly-wired Dante
Flash x3
Network.
If the green indicator is flashing, the unit is the clock
master.
If the green indicator is lit, the unit is the clock slave and the
clock is synchronized.
[SYNC] Indicators Description
A non-GbE-com-
(green) (orange)
patible device is
connected.
Light Light
or flash
The [SECOND-
ARY] connector
(green) (orange)
has taken over
communications
during redundant
Light Flash
network operation.
or flash
An abnormality
has occurred on
the circuit con-
(green) (orange)
nected to the
[SECONDARY]
connector during
Light Flash x2
redundant net-
or flash
work operation.
Possible Solution
Set the clock mas-
ter and sampling
frequency cor-
rectly on the
RSio64-D-native
device or in Dante
Controller.
Make sure that the
Ethernet cables
are not removed or
short-circuited.
Make sure that the
Ethernet cables
are connected cor-
rectly.
Possible Solution
When transferring
audio via Dante,
use device that
supports GbE.
Check the circuit
connected to the
[PRIMARY] con-
nector.
Check the circuit
connected to the
[SECONDARY]
connector.