Yamaha QY700 Owner's Manual page 79

1. SONG PLAY
10. Loop switch; locations 1 and 2
• Set the loop feature ON when you want to repeatedly play a
specific area of the selected song.
• When loop play is in effect, locations 1 and 2 set the start
and end points of the loop (by measure number). Even when
loop play is not in effect, you can jump to location 1 or 2 at
any time by pressing
LOOP
Loop on
0101
1101
OFF
Loop off
001,...,999
Locations 1/2
1. Press [D2] as necessary to move the cursor to
the loop-switch area or either of the location values.
2. Switch the value using the data dial or
• To set location 1 or 2 equal to the value of the current meas-
ure, hold down
11. Tempo and meter
• The tempo value sets the tempo for recording or playback
of the song.
• Each song stores its own tempo value.
• The meter setting area shows the meter for the current meas-
ure.
78
or , respectively.
/ .
and press or .
Chapter 2. SONG MODE
25.0,...,300.0 (= )
Tempo
0101
1101
Meter View only
1. Press [D3] to move the cursor to the tempo
area.
2. Set the appropriate value using the data dial,
or the numeric keypad.
• The meter values are set in Song Recording. (
12. Click mode, click beat, and count
• These parameters set up the sequencer's click sound.
• The beat value sets the click interval.
• The mode setting determines when the click feature is
used.
• The count value sets the number of preliminary meas-
ures used at start of realtime recording.
Click mode:
0101
1101
Off
Disables the click feature.
Rec
Use click for realtime and punch recording only.
Ply
Use click for realtime recording, punch recording,
and playback.
All
Always use click.
Click beat:
, , , ,
Count:
Off, 1,...,8Ms
1. Press [D4] as necessary to move the cursor to
the appropriate click parameter.
2. Set the value using the data dial or
/ ,
p.111)
/ .