Click - Yamaha QY700 Owner's Manual

5. Click

F1 F2
• Here you can make settings for the Click sound that uses
the QY700's tone generator block or an external MIDI tone
generator.
• Since the QY700 does not have a dedicated tone generator
for the click, simply outputting a click signal does not nec-
essarily mean that a click will sound. Also, the click sound
will change depending on the Voice mode settings.
• Find a part for which a drum voice is selected, and then set
the channel here so that that part will sound. Then specify
the note(s) of the drum voice with which the click will be
sounded.
1. Press .
The indicator located above
will enter Utility mode.
2. Press (Click) to access the Click page.
3. Move the cursor to the parameter that you wish to set.
4. Use / , the data dial, or numeric keypad
set the value.
• The initial settings are as shown in the screen above.
F3 F4 F5 F6
will light, and you
to
Chapter 6. UTILITY MODE
1. Channel
• Specify the part and the tone generator on which the click
will be played.
• Find a part for which a drum voice is selected, and set this
channel setting so that that part will be played.
• So that you can check whether or not the click will sound,
set the song play Click Mode to "All" so that the click will
always be played. (
• To avoid problems, set the Channel to "Off" for TG or MIDI
OUT if they are not being used for the click.
TG: Off, 01 – 32
Sound the click using the QY700's tone
0101
1101
generator block.
MIDI A: Off, 01 – 16 Sound the click on an external MIDI
tone generator connected to the MIDI
OUT-A connector.
MIDI B: Off, 01 – 16 Sound the click on an external MIDI
tone generator connected to the MIDI
OUT-B connector.
5. Click
System
MIDI
MIDI filter
Sequencer
Click
Fingered chord zone
p.72)
297
6