Table of Contents
Advertisement
7. Song Jobs
5. Offset
• This parameter adds a fixed value to each of the Rate-ad-
justed gate times. A setting of 0 produces no change. Posi-
tive values increase the gate time, while negative values
decrease it.
JOB 04 CRESCENDO
• You use this job to apply a crescendo or decrescendo to the
specified range of notes (pitches) in the specified segment
of the designated track. The QY700 produces the effect by
applying a slight velocity adjustment (offset) at the begin-
ning of the segment, with the offset increasing gradually up
until the end of the segment.
1. Track setting: TR
• This parameter selects the sequence track to which adjust-
ment is applied.
01,...,32
0101
1101
2. Segment and notes (M and Note=)
• The two boxes at the top of the screen (to the right of the M)
select the track segment over which the crescendo or di-
minuendo is created. The first box sets the measure and beat
for the start point; the second box sets the end point. The
Note boxes select the range of notes (pitches) to be targeted
by the adjustment: notes with pitches outside this range are
not affected.
148
Original gate timing
(Gate)
Offset = -20
(Gate)
Offset = +20
(Gate)
-9999,...,+0000,...,+9999
0101
1101
Measure: beat
0101
1101
Note range
3. Range
• You use the Range parameter to set the intensity of the cre-
• The Range setting selects the value added to the velocities
• Velocity cannot be less than 1 or higher than 127. Adjusted
Chapter 2. SONG MODE
32
32
32
12
12
12
52
52
52
001:1,...,999:8
C-2,...,G8
scendo.
of notes at the final meter and beat of the segment. The
QY700 gradually increases the amount added to (or sub-
tracted from) the velocities within the segment, beginning
with a "0" amount at the beginning of the segment, and
ending with the full Range amount at the end of the seg-
ment.
valves below 1 are raised to 1, adjusted values above 127
are set to 127.
48
48
28
28
68
68
Advertisement
Table of Contents
