Siemens SIMOTICS T-1FW6 Series Configuration Manual page 65

Note
Installation device
Because of the numerous installation situations and installation constraints, it is not possible
to specify a general joining fixture.
Risk of burning when touching hot surfaces
There is a risk of burning when touching hot surfaces immediately after the motor has been
operational.
• Wait until the motor has cooled down.
Danger to life when the cooling system bursts
The motor will overheat if it is operated without cooling. When cooling water enters the hot
motor, this immediately and suddenly generates hot steam that escapes under high
pressure. This can cause the cooling water system to burst, resulting in death, severe injury
and material damage.
• Never operate the motor without cooling.
• Only commission the cooling water circuit when the motor is in a cool condition.
Risk of burns when hot cooling water escapes
There is a risk of burns caused by escaping hot cooling water and steam if you open the
cooling circuit of a motor that was previously in operation.
• Do not open the motor cooling circuit until the motor has cooled down.
Risk of electric shock due to incorrect connection
There is a risk of electric shock if direct drives are incorrectly connected. This can result in
death, serious injury, or material damage.
• Motors must always be precisely connected up as described in these instructions.
• Direct connection of the motors to the three-phase supply is not permissible.
• Consult the documentation of the drive system being used.
1FW6 High Speed built-in torque motors
Configuration Manual, 01/2020, 6SN1197-0AE03-0BP3
WARNING
WARNING
CAUTION
WARNING
Mechanical properties
3.5 Service and inspection intervals
63