Table of Contents
Advertisement
Adjusting for various rack types
The standard rail components can accommodate racks with square or untapped round holes with a depth of 24 inches to 34
inches.
Using the rail adapter hardware, the following additional rack mounting types and depths can be accommodated:
● Racks with depths of 34 inches to 36 inches
● Racks with tapped holes, M6 or 12/24
● Racks with tapped holes, M5 or 10/32
Installing the rails using the adapter hardware
About this task
Only use this procedure if the rack is 34 inches to 36 inches deep and/or the rack has tapped holes that are M5, M6, 10/32, or
12/24.
The front edge of each rail is stamped L or R for left and right sides, when facing the front of the rack. Since the brackets cover
these markings, make a note as to which rack is L and which rack is R.
Use a #2 Phillips screwdriver with a shank diameter less than 7.0 mm and the wrench that was included in the kit to tighten the
nuts.
CAUTION:
The adapter kit is only for static applications where the rack will not be moved. If the rack is to be
moved, remove the shelves before moving the rack.
Steps
1. Attach a long bracket to the front of each rail using four M5 screws into the first (top), second, fourth, and sixth holes.
2. Attach a short bracket to the rear of each rail using two M5 screws into the top and bottom holes.
Install the Disk Shelves in the Rack
23
Hide quick links:
Advertisement
Table of Contents
