3Section 3: Configuration Of Reference Reflector; Overview; Safety Messages - Emerson Rosemount 5900 Instruction For Installation, Configuration, And Operation

Manual Supplement
00809-0200-5900, Rev AC
Section 3
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 29
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 29
Configuration using TankMaster WinSetup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 30
3.1

Overview

The information in this section covers configuration and calibration of the Reference Reflector
for proof testing the Rosemount
3.2

Safety messages

Procedures and instructions in this section may require special precautions to ensure the safety
of the personnel performing the operations. Information that raises potential safety issues is
indicated by a warning symbol (
an operation preceded by this symbol.
Failure to follow safe installation and servicing guidelines could result in death or
serious injury:
Make sure only qualified personnel perform the installation.
Use the equipment only as specified in this manual. Failure to do so may impair the
protection provided by the equipment.
Do not perform any service other than those contained in this manual unless you are
qualified.
Physical access
Unauthorized personnel may potentially cause significant damage to and/or
misconfiguration of end user's equipment. This could be intentional or unintentional and
needs to be protected against.
Physical security is an important part of any security program and fundamental to
protecting your system. Restrict physical access by unauthorized personnel to protect end
user's assets. This is true for all systems used within the facility.
Configuration of Reference Reflector
Configuration of Reference
Reflector
™
5900 Radar Level Gauge.
). Refer to the following safety messages before performing
Section 3: Configuration of Reference Reflector
November 2019
29