Step 6: Calibrating The Sensor; Step 7: Taking Beam Check Exposure; Step 8: Taking A Ball Phantom Exposure - Planmeca ProOne Technical Manual

Chapter E: CALIBRATIONS

1.9 Step 6: Calibrating the sensor

Refer to the Planmeca Device Tool manual, publication number 10031558.

1.10 Step 7: Taking beam check exposure

Refer to the Planmeca Device Tool manual, publication number 10031558.

1.11 Step 8: Taking a ball phantom exposure

Refer to the Planmeca Device Tool manual, publication number 10031558.
In case of test failure, see the ball phantom and patient support table adjustment
instructions in this manual.
Remove the ball phantom from the patient support table. You have now successfully
completed the entire beam adjustment and calibration procedure.
Technical manual
1 ADJUSTING AND CALIBRATING X-RAY BEAM
Planmeca ProOne 111