Optional Extension Brackets - PCchips M810 series User Manual

Optional Extension Brackets

For this mainboard, you can also obtain a USB module extension
bracket. Install them by following the steps below.
Note: All the ribbon cables used on the extension brackets have a
red stripe on the Pin-1 side of the cable.
Extended USB Module
This module bracket has two USB ports for more USB devices
(USB port 3-4).
JUSB1 Header
+5V 1
2 +5V
P0- 3
4 P1-
P0+ 5
6 P1+
GND 7
8 GND
Key 9
10 NC
1. Locate the JUSB1 header on the mainboard.
2. Plug the bracket cable onto the JUSB1 header.
3. In the system chassis, remove one of the expansion slot covers
and install the extension bracket into the opening. Use the
screw that held the slot cover to secure the extension bracket to
the chassis.
2: Mainboard Installation
15