Professional Installer's Responsibility - Beckett CG15 Manual

Professional Installer's Responsibility

Explosion, Fire, and Asphyxiation Hazard
Professional Service Required.
Please read all instructions before proceeding. Follow all
f
instructions completely.
This equipment must be installed, adjusted and started
f
by a qualified service agency that is licensed and
experienced with all applicable codes and ordinances
and responsible for the installation and commissioning
of the equipment.
The installation must comply with all local codes and
f
ordinances having jurisdiction and the latest edition of
the National Fuel Gas Code ANSI Z223.1 (NFPA 54) and
CAN1-B149.1 in Canada.
Burner must be used within the limits of Table 1.
f
Fire Hazard: Overheating
Should over-heating occur:
Shut off the manual gas control to the
f
appliance.
DO NOT shut off power to the equipment,
f
allow the blower and pumps to continue
running.
CG15, CG25, CG50 Burner Manual, Form No. 6104BCG50
Special Requirements:
When contacting Beckett for service information — Please
have the burner serial number and contractor start-up form
available when calling or writing. You will find the serial
number on the label located on the left rear of the burner.
Concealed damage – If you discover damage to the burner
or controls during unpacking, notify the carrier at once and
file the appropriate claim forms. Do not install a burner or
control that has been damaged.
FOR OUTDOOR USAGE it is the responsibility of the OEM
equipment manufacturer to protect the burner system
and components from exposure to water in the end-use
application.
This burner is UL listed for use
in the US or Canada per ANSI/UL
295 & CSA /CGA 3.4. For use with
natural gas or propane.
If any of these instructions are not clear,
Call Beckett at 1-800-645-2876
for assistance.
Section: General Information — 5