Update Sci_Config.hpc; Run Sm_Config - Sun Microsystems Sun HPC 3.0 Manual

== Programming is done ... Please verify the following information:
sciadm $Revision: 2.30 $
DOLPHIN SBus card (SBus2b) found in SBus slot 0 on Board# 0, card slot 0.
Adapter number:
NodeId:
Slot Number:
System Board Number:
Card Slot Number:
Adapter Serial Number:
Fcode Version:
Fcode checksum:
Basic FPGA checksum:
Alternative FPGA checksum: 0xaf0c0c7d
== Programming done ... remember to reboot the system when finished

Update sci_config.hpc

Update the /opt/SUNWsma/sci_config.hpc file to incorporate the information
provided by the sciconf output.

Run sm_config

Execute the sm_config command as root on the node that contains the
sci_config.hpc file.
If possible, do this from a console terminal so you can see the output it generates. If
this is not possible, examine the output in /var/adm/messages. The following
example shows the output that would be generated for the four-node, nonstriped
sample configuration shown in Figure 3–1.
Note - Do not press Return when the sm_config output pauses. Go to the next
section first.
# /opt/SUNWsma/bin/sm_config -f ../sci_config.hpc
For Host #0 (node3), adapter details :-
Adp #0 :- serial no = 6148; bus slot = 0;
For Host #1 (node4), adapter details :
Adp #0 :- serial no = 6520; bus slot = 0;
0
220 (0xdc)
0 (0x00)
0 (0x00)
0 (0x00)
6269
Revision: 2.18
0x8906bca8
0xaf0c0c7d
Adding or Replacing SCI Adapter Cards
(Continuation)
35