Teaching - HomeMatic HM-LC-Sw1-FM Installation And Operating Manual

7.2 Teaching

Please read this section completely before starting
with any teaching!
Training requires that both devices to be connected
are put into teach mode and the desired channel
must be selected for training.
The flush-mount actuators have no special teach
button. Connect the mains power capable buttons
for teaching to the button inputs (see the Installation
section). Teaching a certain actuator channel
requires pressing and holding the respective
channel button (one of the two buttons ▲ or ▼ for
the blind actuators) for about 4 seconds. Teach
mode is indicated by the device LED flashing
continuously.
If no teaching occurs, teach mode is automatically
ended after 20 seconds. If other devices are in teach
mode, these are taught.
40