Connecting A Microphone - Yamaha Tyros3 Owner's Manual

Connecting a Microphone

By connecting a microphone, you can enjoy singing along with your keyboard perfor-
mance or with Song playback (KARAOKE). Make sure you have a conventional dynamic
microphone.
1
Set the [TRIM] control on the rear panel and the [INPUT VOL-
UME] on the front panel both to "MIN."
2
Connect a microphone to the [L/L+R/MIC] jack.
3
Turn the power on.
4
Adjust the [TRIM] control and [INPUT VOLUME] while singing
into the microphone.
Adjust the controls while checking the SIGNAL lamp. Make sure to adjust the
controls so the lamp lights in green or orange. Make sure that the lamp does not
light in red, since this indicates that the input level is too high.
Disconnecting the microphone
1
Set the [TRIM] control and the [INPUT VOLUME] to "MIN."
2
Disconnect the microphone from the Tyros3.
A dynamic microphone with an imped-
ance of 250 ohms is recommended.
You can also connect a guitar to the
LINE IN/MIC [L/L+R/MIC] jack in the
same way as connecting a microphone.
To avoid producing noise which is
picked up from the jack, always
set the [INPUT VOLUME] to mini-
mum when nothing is connected
to the [L/L+R/MIC] jack.
You may find that microphone sound is
distorted even though the SIGNAL lamp
does not light in red. If so, try setting
the [TRIM] control close to "MIN" and
adjusting the [INPUT VOLUME] control
until the level is appropriate.
Make sure lamp does
not light in red.
Set the [INPUT VOLUME] to the mini-
mum position before turning off the
power.
Tyros3 Owner's Manual • 91
NOTE
NOTE
IMPORTANT
NOTE
10
10
NOTE