Connections; Using Tyros3 With Other Devices; Connecting Audio Devices - Yamaha Tyros3 Owner's Manual

Connecting Audio Devices

Connecting the Optional Yamaha TRS-MS02 Speaker
Use the [TO RIGHT SPEAKER], [TO LEFT SPEAKER] and [TO SUB WOOFER L/R] jacks. See page 100.
Using External Audio Devices for Playback
The [LINE OUT] jacks are used to send the Tyros3 output to a keyboard amplifier, ste-
reo sound system, mixing console, or tape recorder. If you are connecting the Tyros3 to a
mono sound system, use only the [L/L+R] jack. When only this jack is connected (using
a standard phone plug), the left and right channels are combined and output through this
jack—allowing you have a mono mix of the Tyros3's stereo sound.
10
10
88 • Tyros3 Owner's Manual

Connections

– Using Tyros3 with Other Devices –
CAUTION
Before connecting the instrument to other electronic components, turn off the power of all compo-
nents. Also, before turning any components on or off, make sure to set all volume levels to minimum
(0). Otherwise, electrical shock or damage to the components may occur.
IMPORTANT
Since the Tyros3 has no built-in speakers, you need to monitor its sound output via external audio
equipment. Alternatively, you could use a pair of headphones (page 15).
Phone plug
(standard)
Audio cable
Powered speakers
Input jack
Phone plug
(standard)
NOTE
You can send a specific part to desired
LINE OUT jack(s). The operation display
can be called up: [MIXING CONSOLE]
→ TAB [
Q Q Q Q ][ W W W W ] LINE OUT. For details,
refer to the Reference Manual on the
website.
NOTE
You can also use the [AUX OUT/LOOP
SEND] jacks instead [LINE OUT] jacks.
However, the output volume from [AUX
OUT/LOOP SEND] cannot be controlled
by MASTER VOLUME.
CAUTION
When the Tyros3's sound is output
to an external device, first turn on
the power to the Tyros3, then to
the external device. Reverse this
order when you turn the power off.