Yamaha Tyros3 Owner's Manual page 86

4
To call up the relevant Edit display, use the [2 ▲▼]/[3 ▲▼]
(ENTER) buttons.
For some items, the Edit display may not be shown, but the setting or change
may be executed.
5
Press the [2 ▲▼] (UP/DOWN) buttons to select the setting or
change the value, then press the [3 ▲] (OK) button.
This can also be done by using the [DATA ENTRY] dial and the [ENTER] but-
ton.
6
To actually apply all settings changed in the Internet Settings
display, press the [7 ▲▼] (SAVE) button.
To cancel, press the [8 ▲▼] (CLOSE) button.
Connection-Related Settings
Depending on your connection environment, you may need to make the following settings for connecting to the Inter-
net.
● LAN Page
The settings here are necessary when the DHCP is not used. These settings are necessary not only for cable LAN con-
nection but also wireless LAN connection.
Use DHCP
DNS server 1/2
IP address/Subnet mask/
Gateway
● Wireless LAN Page
The settings here are necessary only when using a USB wireless LAN adaptor. Make sure to set them to the same set-
9
9
tings as that of the Access Point.
Wireless networks
SSID
Channel
Encryption
WEP key
● Others Page
Proxy settings are necessary only when using a proxy server.
Proxy server/Proxy port/
Non-proxy server
After entering all necessary settings, you can check detailed information on the current connection by selecting the
"Connect Information" menu on the OTHERS Page.
86 • Tyros3 Owner's Manual
5
Determines whether or not DHCP is used.
Determine the addresses of primary and secondary DNS servers. These settings must be
made when "Use DHCP" above is set to "ON (set DNS manually)" or "OFF."
Determine IP address, subnet mask and gateway server address. These settings must be
made when "Use DHCP" above is set to "OFF."
Calls up the access point list. Select the desired access point by using the [B]/[C] buttons
and press the [G] (OK) button.
Determines the SSID setting. (SSID is an identification name for specifying a particular
network over a wireless LAN connection.)
Determines the channel.
Determines whether or not the data is encrypted.
Determines the WEP key. This setting must be made when Encryption above is enabled.
Determines the proxy server name, port number and host name for non-proxy server.