5.2.3
Separate EIS Annunciator Removal
The Mil-Spec EIS annunciators can be removed using the following procedure:
1. Remove the lens holder from the indicator.
2. Remove the lamp from the lens holder.
3. Remove the MS25041 assembly.
ITEM
OTY
PART NUMBER
1
MS25041-4-327
1
2
1
MS25041-2-327
3
1
MS25041-4-330
4
1
MS25041-2-330
5.2.4
Separate EIS Annunciator Re-installation
Re-installation of the annunciators is accomplished using the following procedure:
1. Insert the MS25041 assembly without lens holder from the forward side of the panel and secure.
2. Install lamp on the lens holder.
3. Install and secure lens holder on the indicator.
190-02246-11
Rev. 1
ANNUNCIATOR, YELLOW, PRESS TO FIT FOR 28V
AIRCRAFT
ANNUNCIATOR, RED, PRESS TO FIT FOR 28V AIRCRAFT
ANNUNCIATOR, YELLOW, PRESS TO FIT FOR 14V
AIRCRAFT
ANNUNCIATOR, RED, PRESS TO FIT FOR 14V AIRCRAFT
Figure 5-4 Separate EIS Annunciator Installation
DESCRIPTION
GI 275 Part 23 AML STC Maintenance Manual
Page 5-7