Restoring The Factory-Programmed Settings; Restoring The Factory-Programmed System; Restoring The Factory-Programmed Settings Independently By Item - Yamaha PORTATONE PSR-OR700ж Owner's Manual

Restoring the Factory-programmed Settings

CAUTION
This operation deletes all your
original data for the respec-
tive item (MIDI SETUP, USER
EFFECT, MUSIC FINDER, and
FILES&FOLDERS).
72 PSR-OR700 Owner's Manual
4
Press the [8 π π ] (OK) button to actually enter the new name and
π π
return to the previous display.
• Deleting characters
Move the cursor to the character you wish to delete by using the DATA
ENTRY dial, and press the [7 † ] (DELETE) button. To delete all charac-
ters on the line at once, press and hold the [7 † ] (DELETE) button.
• Entering marks
1 After actually entering a character by moving the cursor, press the
[6 † ] button to call up the mark list.
2 Use the DATA ENTRY dial to move the cursor to the desired mark,
then press the [8 π ] (OK) button.
• Entering numbers
First, select one of the following: "ABC" "CASE" (half-size capital alpha-
bet) and "case" (half-size lowercase alphabet). Then, press and hold
down the appropriate button, [2 π† ]–[5 π† ], [6 π ] and [7 π ] but-
ton, for a while, or press it repeatedly until the desired number is
selected.
• Inserting a Character
1 Move the cursor to the desired position.
Use the same operation as in "Deleting Characters" above.
2 Press the [2 π† ]–[6 π† ], or [7 π ] buttons to enter numbers and
symbols.
3 Press the [8 π ] (OK) button to enter characters.
• Entering a Space
1 Move the cursor to the desired position.
Use the same operation as in "Deleting Characters" above.
2 Press [6 † ] button to call up the mark list.
3 Make sure the cursor is at the beginning space (blank) of the mark list,
and press the [8 π ] (OK) button.
Restoring the Factory-programmed
Settings

Restoring the Factory-programmed System

While holding the C6 key (right-most key on the keyboard), turn the [POWER] but-
ton ON.
This operation has the same result as and is a shortcut for the System Setup restore
operation explained in step 2 of the following section.
Restoring the Factory-programmed Settings
Independently by Item
1
Call up the operation display.
[FUNCTION] → [J] UTILITY → TAB [ √ ][ ® ] SYSTEM RESET