Yamaha PORTATONE PSR-OR700ж Owner's Manual page 89

8
Use the [7 π † ]/[8 π
π † π π † †
If you want to edit the effect parameters, go on to the next operation.
■ Editing and Saving the effect
9
Press the [F] (PARAMETER) button to call up the display for editing
the effect parameters.
10
If you have selected one of the DSP 2-4 effect blocks in step 5:
You can edit its standard parameters as well as its variation parameter.
To select the standard type of parameters, press the [B] button. To select its
variation parameter, press the [E] button.
10
10
11
Select one of the parameters you want to edit by using the [4 π
[5 π † ] buttons.
π † π †
π †
Available parameters differ depending on the selected Effect type.
12
Adjust the value for the selected parameter by using the [6 π
[7 π † ] buttons.
π † π †
π †
If you have selected the REVERB, CHORUS or DSP1 effect block in step 5:
Adjust the Effect Return Level by pressing [8 π† ] button.
13
Press the [I] (SAVE) button to call up the display for saving your origi-
nal effect.
† ] buttons to select the effect TYPE.
π † π π † †
11 12
Editing the Volume and Tonal Balance (MIXING CONSOLE)
13
† ]/
π † π †
π †
† ]/
π † π †
π †
Re-selecting the Effect block,
category and type
Use the [1 π† ]–[3 π† ] but-
tons. The re-selected effect con-
figuration is displayed at the
upper left side box in the display.
Effect Return Level:
Determines the level or amount
of effect applied.
This is set for all parts or channels.
PSR-OR700 Owner's Manual 89