Yamaha EX5 Owner's Manual page 140

Pan
The same as the one in the EP Pickup. See page 126
for information.
10: Seismic
The Seismic, as its name implies, makes the sounds
roar. The input signal is sent to the time-variant low-
boost filter, then passed through the overdrive. Since
the low-boost amount can be controlled by the EG,
Seismic will not only emphasize the bottom of the
sounds but provide with a compressor type effect. Also,
since the overdrive is effective for each note, different
from a conventional effector, Seismic can offer you a
new dimension to your sounds.
Attack/Decay/Sustain
EG Drive
Depth
Overdrive
Input
Input
LBF
time variant
Low-Boost filter
The underlined items in the diagram are available as the
Destination parameters for the FDSP Controller set (page
141).
Input Level
Sets the input level for the FDSP unit.
Settings: –64~0~+16
Drive
Sets the low-boost amount.
Settings: 0~127
Drive Vel (Drive Velocity)
Sets the velocity sensitivity for the low-boost
amount. The low-boost amount can be controlled by
the velocity at which the note played on the
keyboard.
Settings: –64~0~+63
Drive K.Flw (Drive KeyFollow)
Sets the KeyFollow for the Drive. The Drive
KeyFollow function controls the amount of the low-
boost in accordance with the notes played on the
keyboard. When set to a positive value, the higher
the note played on the keyboard, the greater the low-
boost becomes. When a negative value is set, the
lower the note played, the greater the low-boost
becomes.
Settings: –64~0~+63
Highpass Output
Output
HPF
Saturation
Drive EG (Drive Envelope Generator Depth)
Sets the EG depth to affect the amount of the low-
boost.
Settings: –64~0~+63
Drive EG Vel (Drive Envelope Generator
Velocity)
Sets the velocity sensitivity for the Drive EG. The
EG depth can be controlled by the velocity at which
the note played on the keyboard.
Settings: –64~0~+63
Attack Time
Sets the amount of time from when the note is
played to the maximum level.
Settings: 0~127
Attack T.Kf (Attack Time KeyFollow)
Sets the KeyFollow for the Attack Time. This
KeyFollow function controls the attack time in
accordance with the notes played on the keyboard.
When set to a positive value, the higher the note
played on the keyboard, the shorter the attack time
becomes. When a negative value is set, the lower the
note played, the shorter the attack time becomes.
Settings: –64~0~+63
Decay Time
Sets the EG decay time (the time of decay from the
maximum level until the sustain level).
Settings: 0~127
Decay T.Kf (Decay Time KeyFollow)
Sets the KeyFollow for the Decay Time. This
KeyFollow function controls the decay time in
accordance with the notes played on the keyboard.
When set to a positive value, the higher the note
played on the keyboard, the shorter the decay time
becomes. When a negative value is set, the lower the
note played, the shorter the decay time becomes.
Settings: –64~0~+63
Sustain Lvl (Sustain Level)
Sets the EG sustain level (the level to be reached
from the maximum level).
Settings: 0~127
140