Arp Sw (Arpeggio Switch); Arp Midi A/B (Arpeggio Midi Out A/B; Arp Type (Arpeggio Type); Arp Tempo (Arpeggio Tempo) - Yamaha EX5 Owner's Manual

Music synthesizer / realtime control / extended synthesis / tone generator / realtime control / extended synthesis
Hide thumbs Also See for EX5:
Table of Contents

Advertisement

Arp Sw (Arpeggio Switch)

Turns the Arpeggiator on and off.
Settings: off, on
The ARPEGGIO key on the front panel also serves the
same function. However, to actually activate the
function, in the LYR (Layer) screen of each part, set the
Layer Sw (Layer Switch) and the Arpeggio Switch to
"on" (see page 166).

Arp Type (Arpeggio Type)

Sets the arpeggio type.
Settings: See the Arpeggio Type List in the separate Data
List book.

Arp Tempo (Arpeggio Tempo)

Sets the arpeggio tempo.
Settings: 30~250

Tempo Ctrl (Tempo Control)

Sets whether one of the Knobs controls the arpeggio
tempo, or not.
Settings: off, knob 1~6

Arp Hold (Arpeggio Hold)

Sets the Arpeggio Hold to "on" or "off." When
Arpeggio Hold is set to "on," even if you remove
your fingers from the keyboard after playing, the
arpeggio will continue to loop indefinitely.
Settings: on, off

Arp Note LimitL (Note Limit Low)

Sets the lowest note of the arpeggio range on the
keyboard.
Settings: C–2~G8
The lowest note you set here and the note set for the
Arp Note High (Note Limit High) shown below,
determine the range of notes within which the
arpeggios will play.

Arp Note LimitH (Note Limit High)

Sets the highest note of the arpeggio range on the
keyboard.
Settings: C–2~G8

Arp MIDI Ch (Arpeggio MIDI Channel)

Sets the MIDI channel for the Arpeggiator. The
voice of the part assigned to the same MIDI channel
is arpeggiated.
Settings: 1~16

Arp MIDI A/B (Arpeggio MIDI OUT A/B)

Sets the phrase of the Arpeggiator MIDI note to
output from each MIDI OUT A/B when set to "on."
When set to "off," no notes are output.
Settings: on, off
Arpeggio MIDI Out A/B is available for EX5. In the
case of EX5R and EX7, only a set of Arp MIDI Out is
available.
[F6]: EFCT (Effects)
These are parameter settings related to the System
Effects (effects equally applied to the entire parts).
When the EFCT menu is selected using [F6], the
following menu will be displayed.
[F6]: TYPE
[F7]: REV (Reverb)
[F8]: CHO (Chorus)
The Insertion Effects (effects applied to each part) is not
set here, but in Voice Edit mode (page 105).
For more information about effects, see page 65.
[F6]: TYPE
Sets the type of Reverb and Chorus effects. You can set
the send and return levels of each effect unit to
complete the total amount of effect signal for all parts.
1

Rev Type (Reverb Type)

Selects the type of reverb for the Reverb unit.
Settings: 00 (off)~12
For more information about each type of reverb, see the
Effect Type List in the separate Data List book.
161
F6
F7
F8
3
1
4
5
2
6
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ex5rEx7

Table of Contents