Clearaudio Tangent User Manual page 18

Tangent
Bedienungsanleitung
3. Mount the tonearm base
Mount the tonearm base on a clearaudio turntable:
Fix the tonearm base with the three screws and the hex key wrench (#3) provided onto
the dry and clean surface of the turntable's proper part.
Mount the tonearm base on a turntable of other manufacturers:
In order to mount the tonearm base on the turntable chassis you will first have to place
three drills into the turntable chassis. To find out the right position of these drills please
take the measures out of the sketch (also delivered). For this step use an 3,3mm drill.
After you have drilled the three holes, cut the windings with a proper screw-tap. If the
material of the turntable chassis is not suitable to be fitted with windings please use an
4,5mm drill for the holes. In this case you will need some longer screws with nuts to fix
the tonearm base.
Now you can mount the tonearm base on the clean and dry surface of the turntable
chassis.
Seite/Page 18  clearaudio electronic GmbH 2005