Data Format - Panasonic EYFR03 User Manual

Data Format

The below tables show the data available for the input and output slots. The offsets are relative
to the start address for each slot's address space.
Tool IO Module Input
Offset Size Name
0 1 Job Number
1 1 Parameter
Number
2 1 Tool Number
3 1 Status
4 1 Count
5 1 Batch
6 2 Timestamp Date
8 4 Timestamp Time
12 2 Last Parameter
Write Date
14 4 Last Parameter
Write Time
18 4 Tightening ID
22 1 Result Status
23 14 Tool Serial
Number
37 25 VIN
Tool IO Module Output
Offset Size Name
0 1 Job Number
1 1 Parameter
Number
2 1 Batch
3.0 bit Suspend
3.1 bit Batch Reset
3.2 bit Job Step
Increment
3.3 bit Job Step
Decrement
3.4 bit Batch Increment
EYFR03 User Manual
Chapter 10: PROFINET
Type
USINT Job number. (0 means job not running)
USINT Parameter number. (0 means parameter not running.)
USINT Active tool number. (0 means no tool active)
USINT Status of parameter
0 – None
1 – Cycle
2 – Batch
3 – Reject
4 – Batch NOK (batch complete with a counted reject)
USINT Number of tightenings performed in the current batch for the
parameter.
USINT Number of tightenings required for a batch in the parameter.
DATE Date portion of timestamp of the last tightening
TOD Time portion of timestamp of the last tightening
DATE Date portion of the last time the parameter of the last
tightening was written
TOD Time portion of the last time the parameter of the last
tightening was written
UDINT ID number of the last tightening
0 – OK; 1 – NOK
USINT
CHAR[14] Serial number of the tool that performed the last tightening
CHAR[25] VIN of the last tightening.
Type
USINT Job number to run.
USINT Parameter number to run. Ignored if Job Number is not 0.
255 means temporary parameter with information below.
USINT Sets the batch size for the selected parameter. Ignored if Job
Number is not 0. If this value is 0, the parameter size stored
in the EYFR03 will be used.
BOOL When set, suspends on the interface without stopping a
running parameter or job.
BOOL When this value changes from false to true, the batch count of
the currently running parameter on the interface is reset.
BOOL When this value changes from false to true, the EYFR03 will
move to the next step in the active job.
Ignored if Job Number is 0.
BOOL When this value changes from false to true, the EYFR03 will
move to the previous step in the active job.
Ignored if Job Number is 0 or if already on the first step in the
job.
BOOL When this value changes from false to true, the EYFR03 will
increment the count as if a valid tightening was performed.
102 of 110
Description
Description
20 January 2020
v1.6.0