Vin Selections - Panasonic EYFR03 User Manual

VIN Selections

Starting with version 1.2.5, you may configure the EYFR03 to use VIN barcode scans to select a
parameter, group, or job. The selections must be configured via the Assembly Manager
program.
TM
Both the Atlas Copco Open Protocol and EtherNet/IP can provide a VIN to the EYFR03.
VINs received from these protocols will still be placed in the VIN field, but they are ignored by
the VIN selection feature. If a network is able to provide VINs, it is expected that the network
will also control the selection of operations through one of the mechanisms provided in that
protocol.
Settings
No match behavior
Default: Continue
Values: Continue, Stop, Ignore
This setting determines what happens when a selector scan does not match one of the VIN
selections.
When set to Continue, the EYFR03 will store the scan in its Selector field, but will not stop or
change the running operation for a non-matching scan.
When set to Stop, the EYFR03 will discard the scan and blank both the Selector and VIN fields
and will stop the running operation for a non-matching scan.
When set to Ignore, the EYFR03 will ignore any selector scans that do not match one of the VIN
selections and act as if the scan never occurred.
Selection mode
Default: Single Scan
Values: None, Single Scan, Dual Scan, VIN then Selector, Selector then VIN
This setting determines the mode the EYFR03 uses for the VIN Selection feature. The modes
will be described in more detail in the next section.
Second scan timeout
Default: 5
Range: 0-99 seconds
This setting determines how long the EYFR03 will wait for a second scan when using one of the
selection modes requiring two scans. If a valid second scan is not received during the timeout,
the EYFR03 will discard the first scan, and if No match behavior is Stop, will also stop the
running operation.
VIN length
Default: Variable
EYFR03 User Manual 52 of 110 v1.6.0
Chapter 4: 20 January 2020